Turning The Machine On And Off; Turning The Machine On; Turning The Machine Off - Astoria Plus4You Manual De Uso Y Mantenimiento Para El Usuario

7

Turning the machine on and off

7.1 Turning the machine on

After the electric and water connections have
been made by qualified personnel, make certain
that the drainage tray located under the cup support
grille (8) is correctly connected to the drain.
4
8
Make sure all steam taps are closed.
Turn the machine on using the main switch (4)
and follow the indications provided on the ma-
chine's display, as described below.
W h e n t h e m a -
chine is turned on,
it performs the func-
tional test and re-
ports information
regarding the software installed.
XX.XX.XXXX : revision date
RY : revision number
If the result is O.K.
the machine is work-
ing correctly.
If the machine fails
the functional test,
contact the Technical Support Service.
W h e n t h e m a -
chine is turned on, it
will activate the mo-
tor pump installed
and begin to fill the
services boiler and the water heaters for the coffee
(equal to the number of delivery groups installed
on the machine.)
38
FUNCTIONAL TEST
DELN XX.XX.XXXX RY
D.Board Z.ZZ
TEST
-O.K.-
0.0 Bar Press 3.5
08:30 10-MAY-2010
COFFEE
WATER FILLING
In order to remove
the air from the heat-
ers, each time the
machine is turned on
the solenoid valves
of the groups will be activated, making water and
steam come out from the perforated disk of each
group for about 10 seconds.
When the heating
phase of the delivery
groups has finished
(after about 10 min-
utes), signaled by the
disappearance of the "PLEASE WAIT" indication,
it will be possible to make the coffee selections.
For the delivery of hot water and steam, it will be
necessary to wait for the complete heating of the
services boiler.
During the heat-
ing phase of the
services boiler (from
95°C to 98°C), the
machine will execute
a light delivery of water and steam from the hot
water nozzle.
The delivery of
steam and hot wa-
ter, and thus the full
operation of the ma-
chine, will be possi-
ble only at a pressure higher than 0.6 bar.
To avoid the risk of burns, it is advisable to keep
!
hands away from the hot water nozzle, steam
nozzle and delivery groups during the machine's
heating phase.
Before using the machine, run deliveries dry with
i
the filter holder attached for a few seconds to
release any air which may be in the circuit, so that
the delivery groups are completely heated.

7.2 Turning the machine off

To turn the machine off, just use the main switch
(4).
0.0 Bar Press 0.0
08:30 10-MAY-2010
MAKE ATTENTION
WATER/STEAM ESCAPE
0.0 Bar Press 0.0
WAIT PLEASE
Humidity 62% p 32%
0.0 Bar Press 0.0
STEAM ESCAPE
Humidity 62% p 32%
0.7 Bar Press 0.0
08:30 10-MAY-2010
Humidity 62% p 32%
User manual