Sears KENMORE ELITE UltraWash 665.1396 Serie Manual De Uso página 19

Indicators a ndCountdown B ar(onsomemodels)
The indicators will inform you if you are able to add a dish to the cycle
after it has started. It will also inform you if the dishwasher is washing,
rinsing, drying, complete, and/or sanitized. They will show whether the
control is locked and/or the delay option is selected. A series of bars will
count down the duration of the cycle remaining from left to right. Each bar
equals approximately 24 minutes of cycle length. The bars will also count
down the delay feature from left to right, and the delay indicator will be
activated.
Selecting Cycles and Options
1. Select the desired cycle. If you want to run the last cycle that was completed, you can simply press START once to show
which options you used, then press START again to start the cycle.
2. Select the desired options. Not all options are available for every cycle. If an invalid option is selected for a given cycle,
the lights will flash.
Turning OFF/ON the Sound
Press and hold HIGH TEMP for 3 seconds to toggle sound ON and OFF. The sound will not deactivate for cycle interrupt or
service required messages. A screen on the Text LCD will confirm when the sound has been turned off or on.
Ca '}cel A Ojce
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door.
2. Press CANCEL/DRAIN button once. The Cancel/Drain light will light up.
3. Close the door within 3 seconds. The dishwasher starts a drain cycle (if water remains in bottom of dishwasher). Let the
dishwasher drain completely. The Cancel/Drain light turns off after 2 minutes.
You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2. Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser before
restarting your new cycle.
3. Press CANCEL/DRAIN twice to reset the control.
4. Select new cycles and options.
5. Press START/RESUME.
Add s{d? A DsB ,*D sBwc sBe " s $ a q ed
1. Check if Add a Dish indicator is lit.
2. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
3. Check whether the detergent dispenser cover is still closed. If it is open, the wash cycle has already started and adding a
dish is not recommended.
4. If detergent has not yet been used (detergent dispenser cover is closed), you may add a dish.
5. Press START/RESUME.
19