Descargar Imprimir esta página

Poulan Pro PP4620AVL Manual De Instrucciones página 9

Publicidad

Idiomas disponibles

Idiomas disponibles

,_ WARNING:
Remove fuetcap slow-
ly
when refueling.
FUELING
ENGINE
This engine is certified to operate on unleaded
gasoline. Before operation,
gasoline must be
mixed with a good quality synthetic
2-cycle
air-cooled engine oil designed to be mixed at a
ratio of 40:1,
Poulan/WEED
EATER
brand
synthetic
oil is recommended.
Mix gasoline
and oil at a ratio of 40:1, A 40:1 ratio is obtained
by mixing 3.2 ounces of oil with 1 gallon of
unleaded gasoline,
included with this saw is a
3.2 ounce
container
of oil,
Pour the entire
contents
of this container
into
1 gallon of
gasoline to achieve the proper fuel mixture. DO
NOT USE automotive oil or boat oil. These oils
will cause engine damage. When mixing fuel,
follow instructions
printed on containen Once
oil is added
to gasoline,
shake
container
momentarily
to
assure
that
the
fuel
is
thoroughly mixed. Always read and follow the
safety rules relating to fuel before fueling your
unit.
BAR
AND
CHAIN
LUBRICATION
The bar and chain require
continuous
lubri-
cation.
Lubrication
is provided
by the auto-
matic oiler system when the oil tank is kept
filled. Lack of oil will quickly
ruin the bar and
chain.
Too little oil will cause
overheating
shown by smoke coming from the chain and/
or discoloration
of the bar.
In freezing weather
oil will thicken,
making it
necessary
to thin bar and chain oil with a
small amount
(5 to 10%) of #1 Diesel Fuel or
kerosene.
Bar and chain
oil must be free
flowing for the oil system to pump enough oil
for adequate
lubrication,
Genuine
Poulan
or Poulan
PRO
bar and
chain oil is recommended
to protect your unit
against
excessive
wear
from
heat
and
friction.
Poulan
or Poulan PRO
eil resists
high
temperature
thinning,
If Poulan
or
Poulan
PRO
bar
and chain
oil is not
available,
use a good grade SAE 30 oil.
• Never use waste oil for bar and chain lubri-
cation.
• Always
stop the engine
before removing
the oil cap,
IMPORTANT
Experience
indicates
that alcohol-blended
fuels
(called
gasohol
or using
ethanol
or
methanol)
can attract
moisture
which leads
to separation
and formation
of acids during
storage.
Acidic
gas can damage
the fuel
system
of an engine while
in storage,
To
avoid
engine
problems,
the
fuel
system
should
be emptied
before
storage
for 30
days or longer.
Drain the gas tank, start the
engine and let it run until the fuel lines and
carburetor
are empty.
Use fresh fuel next
season,
See STORAGE
section
for addi-
tional information.
AlL
d_WARNING:
The chain
must not
move when the engine runs at idle speed. If
the chain moves at idle speed refer to CAR-
BURETOR
ADJUSTMENT
within
this
manual. Avoid contact with the muffler. A hot
muffler can cause serious burns,
To stop
the engine
move
the ON/STOP
switch
to the STOP position.
To start
the engine
hold the saw firmly on
the ground
as illustrated,
Make
sure
the
chain is free to turn without
contacting
any
object.
Use only 15"-18"
of rope per pull,
Hold saw firmly while pulling
starter rope.
Starter rope handle
I{
, _\_"l
_21"
Leff hand
front
Right foot through
rear handle
IMPORTANT
POINTS
TO REMEMBER
When pulling the starter rope, do not use the
full extent of the rope as this can cause the
rope to break,
Do not let starter
rope snap
back. Hold the handle and let the rope rewind
slowly,
For cold weather
starting,
start the unit at
FULL CHOKE;
allow the engine to warm up
before squeezing
the throttle trigger,
NOTE:
Do not cut material
with the choke/
fast idle lever at the FULL CHOKE
position.
STARTING
A
COLD
ENGINE
(or
warm
engine
after
running
out
of
fuel)
NOTE:
In the following
steps,
when the
choke/fast
idle lever is pulled out to the full
extent, the correct throttle setting for starting
is set automatically.
1. Move ON/STOP
switch
to the ON posi-
tion.
2.
Pull the choke/fast
idle lever out to the full
extent
(to the PULL CHOKE
position).
3.
Pull starter rope quickly
with your
right
hand a maximum
of 5 times. Then, pro-
ceed to the next step.
NOTE:
Ifthe engine sounds as if it is trying
to start before the 5th pull, stop pulling and
immediately
proceed
to the next step.

Publicidad

loading