Poulan Pro PP4620AVHD Manual De Instrucciones página 8

KNOW YOUR SAW
A
dl_ WARNING:
If the saw is operated
with a loose chain, the chah_ could jump off
the guide bar and result in serious injury.
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
CHAIN SAW. Compare the illustrations with your unit to familiarize yourself with the location of the
various controls and adjustments. Save this manual for future reference.
Chah_ Adjustment Tool Front Hand Guard
(Bar Tool) \ f'h
Muffler _ I
Bar Sprocket Chain ""_m _ I
Hole \ k. p n'
,_ Bumper
Spike
Fill Cap
Front Handle
k/ Starter Rope
,_/_ ON/STOP
/ Switch
Fuel Mix Fill Cap
Starter Housing
Throttle
Lock-out
Rear
Handle
Cylinder Cover
Adjusting
Direction
of Chain
Travel
Throttle
Trigger
Chain Brake
Choke/Fast Idle Lever
ON/STOP SWITCH
The ON/STOP SWITCH is used to stop the
engine.
THROTTLE TRIGGER
The THROTTLE TRIGGER controls engine
speed.
THROTTLE LOCK-OUT
The THROTTLE LOCK-OUT must be
pressed before you can squeeze the throttle
trigger. This feature prevents you from acci-
dentally squeezing the trigger.
CHOKE/FAST IDLE LEVER
The choke and fast idle speed are set by pull-
ing the CHOKE/FAST IDLE LEVER out fully
for cold or for refueled starting. The choke
provides additional fuel to the engh_e during
cold starting.
Guide Bar
Chain Brake Nuts
CHAIN BRAKE
The CHAIN BRAKE is a device designed to
stop the chain if kickback occurs. The chain
brake activates automatically in the event of
kickback. The chain brake activates manu-
ally if the front hand guard is pushed forward.
The chain brake is disengaged by pulling the
front hand guard back toward the front han-
dle as far as possible.
CHAIN TENSION
It is normal for a new chain to stretch during first
30 minutes of operation. You should check
your chain tension frequently. See CHAIN
TENSION in the ASSEMBLY section.
_b, WARNING:
Muffler is very hot dur-
ing and after use. Do not touch the muffler or
allow combustible material such as dry
grass or fuel to do so.