Wireless Module; Rs485 Module - Bell & Gossett ecocirc XL Manual Del Usuario

6.2 Wireless Module

Referring to Figure 8 in the appendix, after the module
has been connected, configure it by setting the
parameter "Module" to the value "Wireless", as
described in sec. 4.3.5.2.
6.2.1 Wireless module use
When the wireless module is assembled into ecocirc XL,
and correctly configured, it generates a (type 902.11n)
wireless network accessible (by a mobile phone, tablet
or a PC) using data (S/N and PWD) printed on the label
at the side of the circulator's drive
In particular,
• Network name: "xylemecoxl"_______S/N_______"
where S/N is an 8 character word
• Password: "xylem_______PWD_______" where PWD
is an 8 character word
To access the circulator's web pages using a browser
(on the connected external device), use the web address
"https://xylemecoxl" or type directly "192.168.1.10"
14

6.3 RS485 Module

Referring to Figure 8 in the appendix, after the module
is connected, configure it by setting the parameter
"Module" to the value "RS485", as described in
sec. 4.3.5.2
Accessories
Electronic Drive Manual