Change Pincode; Factory Reset - König SAS-ALARM400 - QIG Manual De Usuario

Delete all detectors in one zone (SAS-ASDW4xx / SAS-ASMS4xx)
1. Long press the numbered button (1 - 4 matching the current zone of the detector) on
the main unit (the corresponding LED lights up)
2. Long press this same button again
3. 4 flashes and 4 tones means all detectors in that zone have been removed.
Zone Type setting
1. Long press the ARM button on the main unit + the numbered button (1 - 4 matching
the zone you want to set) on the main unit (the corresponding LED starts flashing)
2. First set the attribute by shortly pressing one of the four buttons:
1. Normal: follow setting of main unit and only when armed
2. Emergency: always alarm
3. Chime: always doorbell
4. Welcome: doorbell when disarmed, alarm when armed
3. Finally set the delay by shortly pressing:
1. No delay
2. 30 seconds delay
4. A longer tone indicates zone is set successfully
5. Short press ARM button to exit.

Change pincode

1. Remove battery
2. Press and hold any numbered button (1 - 4)
3. Insert batteries
4. Release button after 6 tones have sounded and all LEDs remain on.
5. While all 4 LEDs are lit, enter new pincode (try as many times as needed
6. Confirm new pincode by pressing the ARM button

Factory reset

1. Remove battery
2. Press and hold the ARM button
3. Insert batteries
4. Release button after flashes and tones stop
5. All detectors and remote controls have been removed.
5
English