Collomix CMG 1700 Manual De Servicio página 12

shielded and are unsafe.
mounted on the power tool securely. The pro-
and accidental contact with the grinding disk.
Diamond cup disks must only be used for
ple: Never grind edges with a diamond cup
disk. Diamond cup disks are designed to grind
segments. Lateral stresses on these grinding
disks may cause them to break.
correct size and shape for the diamond cup
disk of your choice.
support the diamond cup disk and will there-
fore lower the risk of breaking.
Never use worn diamond cup disks of larger
power tools. Diamond cup disks for larger
power tools are not designed for the higher ro-
break.
Recoil and associated safety notes
-
or blocking of the insert will cause a sudden
the power tool will be accelerated uncontrol-
For exam-
If e.g. a grinding disk is hooked or blocked inside
the workpiece, the edge of the grinding disk
submerged in the workpiece may get caught
and thus break the grinding disk or cause a re-
coil. The grinding disk will then move towards
the operator or away, depending on the rota-
help prevent a recoil.
body and arms in such a way as to be able to
compensate any recoil. Always use the second
on the tool and greatest possible control in
the event of a recoil, and best possible reac-
will be able to compensate for the recoil force
taken.
tool insert to move across your hand.
which the power tool would move in case of
a recoil.
ners, sharp edges, etc. Prevent the tool inserts
a surface. This could cause a loss of control or
a recoil.
Do not use chain disks or toothed disks. These
control over the power tool.
Rev. 3 / 12
-
-
-
The operator
-