Collomix CMG 1700 Manual De Servicio página 15

Dust extraction
Dust from materials like lead paints, some wood
types and metals may be hazardous to your health.
operator or other personnel in the vicinity.
be processed by specialists.
For best results, use the recommended Collomix
high-performance dust extractor with this power
class P2 is recommended.
working with the dust extractor:
ed by Collomix, and the Collomix extractor of class
and work process.
from entering the environment.
ing.
Operation
age data provided on the type plate must match
the voltage of the power source. 230 V devices can
be operated with 220 V or 240 V power sources.
Switching ON/ OFF
-
To switch on the machine, push the ON/ OFF
-
-
ON/ OFF switch and it will jump back into OFF
Check the cup wheel before use. The cup wheel
must be mounted perfectly and run smoothly. Al-
low the machine to run at idling speed for at least
1 minute before commencing work. Do not use
ately if your adjustments do not result in an im-
-
provement.
First switch on the device, then place the cup wheel
fully and evenly on the surface to be treated. Be
when it is torn from your hands.
best results are achieved without excessive down-
pressure onto the area to be processed. Do not
push down on the grinder, as this might cause the
- machine to stop.
down. The grinding cup on a concrete grinder can
-
See Fig. A1 - A3
-
grinding along wall edges. This will allow the pro-
cessing of areas that would otherwise be inacces-
sible.
Press the hood segment you wish to open slightly
-
forward and push it to the side. The segment is
-
spring-mounted.
To close the segment, simply push it back into
place.
Before opening the hood segment, stop the
machine and pull the cable.
Rev. 3 / 15
The volt-
-
-