Tabla De Contenido; Safety Warnings - Iso-Tech IIT-2301 Manual De Instrucciones

1 Safety warnings
2 Features and layout
3 Specifications
4 Principles of measurement
5 Pre-use checks
6 Insulation tests
7 Continuity and resistance tests
8 Fuse and battery replacement
9 Cleaning, repair & calibration
10 Case and shoulder strap assembly
The ISO-TECH IIT-2301 Insulation and Continuity Tester has
been designed to comply with current lEE Regulations and
International Standards. By using the latest technology, this
instrument will give accurate and reliable results when used in
accordance with these operating instructions.
2

1 Safety Warnings

 Warning! Electricity can cause severe injuries even with
4
low voltages or currents. It is extremely important these
5
instructions are fully read and understood before using this
6
instrument.
7
The following symbols or terms may appear on the
8 instrument or in these instructions:
8
Caution, risk of electric shock

9
Caution, risk of danger. Refer to operating instructions.

9
Direct current

10
Equipment protected throughout by double insulation

or reinforced insulation
Earth

Alternating current

Complies with EU directives

1.1 This instrument must only be used by competent and
trained persons and in strict accordance with these
instructions. If this instrument is used in a manner not
specified in these instructions, the protection afforded by
the instrument may be impaired.
1.2 This instrument must not be used on live circuits. Ensure
the circuit to be tested is de-energised before connecting
the instrument. Fit safety devices to circuit breakers or
isolators, or remove fuses to prevent re-energising of the
circuit before testing is complete.