Installation pressure reducer
There's a pressure reducer included in the installation kit, its function is to regulate the inlet pressure
into the machine to ensure proper operation and to protect the equipment due to the pressure
oscillations within the network oscillations parameters.
Assembly:
1. Remove security blue clips from pressure reducer (depending on model).
2. Connect black tube to the pressure reducer input.
3. Cut a piece from 10 cm (black tube) and connect it between the pressure reducer and the equipment.
4. Put the security blue clips into the pressure reducer (depending on model).
IMPORTANT: The pressure reducer has signaled the direction of water flow.The water
arrow always should be looking to the machine water input.
52