Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1.- VIEWS OF THE RE2 or PLC2 AND CONTROLS. (See figures 4, 5 and 6).
On the figures 4, 5 and 6 have been contemplated all the formats with their different assembling depending on the model.
Please choose the view corresponding to the equipment purchased.
2.- LETTERING CORRESPONDING TO THE VIEWS OF THE EQUIPMENT.
(1)
Input supply plug or terminal.
(2)
Power outlets or terminals.
(3)
Relay interface connector (Optional).
(4)
Input fuses (a or b).
(5)
Input's general MCB or switch.
(6)
Switch
-
.
(7)
Output voltmeter.
(8)
Voltmeter communication switch (three phase equipment).
(9)
Fuse or switch to cancel protections. (Only equipment with optional Hi/low).
(10) Cabinet's door lock.
(11) Ground terminals ( ).
(A)
Display type (A).
(B)
Display type (B).
(C)
Display type (C).
(D)
Display type (D) (Equipment with Hi/Low).
(E)
Display type (E) (Equipment with Hi/Low).
(a)
"Input".
(b)
"Power on".
(c)
"Bypass A (R)".
(d)
"Bypass B (S)".
(e)
"Bypass C (T)".
(f)
"Output".
(g)
"Out of Service" (only on equipment with optional Hi/Low) .
(h)
M "Reset". (Equipment with Hi/Low).
3.-
GENERAL SAFETY INSTRUCTIONS.
• The RE2 voltage stabilisers and the PLC2 Line Conditioners should be considered as transformers or distribution lines
from the point of view of the installation and the electrical safety. These equipment are "transparent" to the input voltage.
By the other hand it should be considered that the equipment will supply output voltage directly from the raw mains,
without the need of the switch (6) necessarily being turned on, if it incorporates a Bypass (equipment with structure as
shown in figure 2). To turn off the power supply you should open the MCB (5).
- 20 -
Publicidad
Capítulos
Tabla de contenido
