Remote Control; Power Source - memorex MVD2113A Manual De Instrucciones

Remote control

Inserting Batteries
1
Open the battery compartment
cover in the direction of the
arrow.
Operation
• Aim the remote control at the remote sensor and
press control buttons to operate.
• Operate the remote control within 30° angle on
either side of the remote sensor, up to a dis-
tance of Approx. 5 meters.
NOTES:
•
Do not leave the remote control unit exposed to direct sunlight or in hot or humid places.
• The remote control unit uses infrared beams to transmit signals, so sunlight or fluorescent light on the remote
sensor may shorten operating distance.
• Incorrect use of batteries may cause them to leak or burst. Read the battery warnings and use the batteries
properly.
•
Do not mix old and new batteries.
• Remove batteries if the remote control will not be operated for an extended period of time.

Power source

AC Outlet
Wider Hole
and Blade
Polarized AC Cord Plug
(One blade is wider than the other)
10
5P20521A [E] P06-11
2
Install two "AAA" batteries
(not supplied), paying attention
to the polarity diagram in the
battery compartment.
TO USE AC POWER
Use the AC polarized line cord provided for operation on AC. Insert
the AC cord plug into a standard 120V 60Hz polarized AC outlet.
NOTES:
• Never connect the AC line cord plug to anything other than the
specified voltage (120V 60Hz). Use the attached power cord only.
• If the polarized AC cord does not fit into a non polarized AC
outlet, do not attempt to file or cut the blade. It is the user's
responsibility to have an electrician replace the obsolete outlet.
• If you cause a static discharge when touching the unit, and the
unit fails to function, simply unplug the unit from the AC outlet,
wait a few minutes, and plug it back in. The unit should return to
normal operation.
10
(Continued)
3
Replace the compartment
cover.
Approx. 5 meters
5/12/04, 2:41 PM