Protecting The Environment - Master DCN 3264 Instrucciones De Servicio

Maintenance and care
The tool must be disconnected from the air supply
before maintenance work is performed.
Keep the tool and the handle clean and free of oil.
Always use a clean cloth for cleaning. Never use brake
fluid, petrol or solvent for cleaning.
The cylinder, the O-ring and the piston ring are
lubricated for the life of the tool under normal operating
conditions. Further lubrication is not necessary.
Should, despite careful manufacturing procedures and
test procedures, the tool fail at some point, have the
tool repaired by an authorised customer service centre
for WÜRTH compressed air tools.
It is imperative you state the article number (see type
plate) of the tool.
Spare parts
It is only allowed to use original spare parts. The use of
other parts can cause damage to the tool.
Attachments
Accessories or attachments that are not recommended
by the manufacturer of this tool are not allowed to be
used

Protecting the environment

Recycling instead of refuse
disposal.
Tools, accessories and packaging
that are no longer useable should
be sent for recycling. For this
purpose send the tools that are no
longer useable to the local recycling
collection point or return them to
WÜRTH.
We reserve the right to make changes without notice
Warranty
For this WÜRTH tool we provide a warranty as per
legal / national stipulations from the date of purchase
(proof of purchase with receipt or delivery note).
Resulting damage will be rectified by replacement or
repair. Damage due to improper handling is excluded
from the warranty.
Complaints can only be accepted if the tool is handed
over, without dismantling, to a WÜRTH subsidiary, your
WÜRTH sales representative or a customer service
centre authorised by WÜRTH for compressed air tools.
Declaration of conformity
We declare with general responsibility that this product
complies with the following standards or standardisation
documents: EN 292-1, EN 292-2, EN 1050,
EN 792-13, EN 12549, ISO 8662-11 as per the
stipulations of the directive 98/37/EC.
07
Adolf Würth GmbH & Co. KG
17