Paper Jam; Cleaning And Maintenance - Primo HSM 225.2 Instrucciones De Servicio

5 Troubleshooting

Paper jam

You have fed in too much paper.
Red LED lights.
The cutting device runs in reverse
for approx. 2 seconds automatically.
Pa per is pus hed out.
NOTICE! Do not press rocker switch alter-
nately forwards/backwards (
Cutting unit could be damaged.
• Pull out the paper from the paper
feed opening.
If the paper is too low and cannot be
taken out: Activate the rocker switch
several times briefl y. Light bar-
rier must be free of obstacles.
• Acknowledge the fault by switching
the machine off and on again.
• Se pa ra te pa per stack.
• Press rocker switch
• Feed pa per successively.
Shredded material container full
Red LED lights.
Paper shredder switches off
NOTICE! Empty the cut material container
immediately, because if it is too full,
malfunctions can occur in the cutting
system.
• Switch equipment off. To do this tap
rocker switch
• Remove full shredded material bag
and insert new bag.
Door open
Red LED lights.
Paper shredder switches off.
• Check whether front door is closed
properly.
For all other malfunctions, check whether the
motor was overloaded before contacting our
customer service. Let the shredder cool down
for approx. 15 – 20 mins. before using it again.
0802
- ).
.
.
HSM 225.2

6 Cleaning and maintenance

Switch off the shredder and pull out the mains
plug. When cleaning only use a soft cloth and
a mild soap-water solution. However, no water
must enter the equipment.
Check that the door switch is working properly:
Warning!
If the following procedure cannot be
performed, switch off the document
shredder, disconnect the mains plug
and contact customer service.
• Insert the mains plug and switch on the
shredder.
• Feed in a sheet of paper and open the front
door while the paper is being drawn in.
The cutting unit must turn off immediately
and the "door open" indicator must light up.
• Close the door.
The cutting unit must not yet restart.
• Pull the paper out of the feed opening. The
light barrier must be clear.
• Switch off the machine and then switch back
on.
The cutting unit starts when paper is fed in.
Oil the cutting unit when
cutting performance de-
creases or the device be-
comes noisy, or every time
you empty the waste con-
tainer (Cross cut only):
• Spray special cutting apparatus oil through
the paper feed opening along the entire width
on to the cutting rollers.
• Run cutting system backwards ( ) without
feeding paper.
Paper dust and particles are shaken off.
9