Proceed As Follows - Columbus AKS 70 BM 62 Manual De Instrucciones

Vacuum sweeper
AKS 70|BM 62
CHAPTER 16 – DISMANTLING/DEMOLITION
____________________________________________________________________________________________________
DISMANTLING AND DEMOLITION ARE A CUSTOMER'S RESPONSABILITY. THESE OPERATIONS MUST BE PERFORMED IN
ACCORDANCE WITH APPLICABLE REGULATIONS, HANDING THE ENTIRE MACHINE OR ITS COMPONENTS TO COMPANIES
SPECIALISED IN SUCH SERVICES.
____________________________________________________________________________________________________
CHAPTER 17 – EMERGENCY SITUATIONS
In the event of any emergency situations such as, for instance: the machine has accidentally been driven over power cables and these have
wrapped around the central brush or side brush, or an unusual noise is heard coming from inside the machine or engine, hot materials,
inflammable liquids, chemical materials in general, poisons etc. have been picked up ETC:
1) Disengage the traction
2) Hardly press the brake pedal
3) Switch off the engine by the key on the dashboard or simply by leaving the driving seat as the safety micro switch under the seat
will automatically turn the engine off.
4) After picking up the above materials, remove the waste container) part. 1 and 2 fig. 7 and clean it, wearing gloves and mask to
protect the airways. Follow the instructions in the "waste container" paragraph.
CHAPTER 18 – TROUBLESHOOTING
Two basic faults can effect AKS 70|BM 62: the machine raises dust during use, or leaves dirt on the floor; causes could be many but if the
machine is carefully operated and routine maintenance is properly carried out, such faults will not occur.
FAULT
The machine raises dust
The machine leaves dirt on the floor

PROCEED AS FOLLOWS:

CAUSE
Suction lever is in OFF position (pulled out)
Filters blocked
Filters damaged
Filters badly fitted
Side seals damaged
The central brush is not well set or is worn
Wires, strings etc. have been picked up
Side seals damaged
Waste container full
29
REMEDY
Turn to ON position (pushed in)
Clean them by "shaking" them using the
provided tools and if necessary take them
off and clean thoroughly
Replace
Fit with the seal provided and make sure
they are well inserted and uniformly well-
secured
Replace
Ad just the central brush and check the
"track"
Remove them
Replace
Empty