Beper 50.921 Manual De Instrucciones página 11

Vacuum Cleaner Use instructions
2. Press the power on/off button located the unit to turn the vacuum cleaner "on".
3. To rewind the power cord, press the cord rewind button with one hand and guide the power cord
with the other hand to ensure that it dose not whip causing damage or injury.
4. To adjust the suction, slide the speed control button on the suction hand to control the suction
power of the vacuum cleaner.
Clean or change dust bag. Fig.1
1. Open the front cover.
2. Take out the rack.
3. Remove the bag for cleaning or change.
Carry and move away the cleaner:
Note: This cleaner have a special feature for handle. You can use it to conveniently carry the cleaner
when the cleaner is in vertical.
And also 3 small direction wheels at the bottom for easy movement on the floor.
Removing & cleaning pre-motor filter and air outlet filter
Warning: Always unplug the unit from electrical outlet before getting out the dust barrel.
Pre-motor filter Fig.2
1. Open the front cover.
2. Take out the rack,then press the thumb position and rotate outward to reach image 3.
3. Remove the inlet filter for cleaning or change.
Air outlet filter Fig.3
1. Press the front cover lock knob to open it
2. Take out the air outlet filter for cleaning or change.
Please note:
The sponge filter material in the cleaner will became dusty over time. This is normal and will not af-
fect the performance of the filter. If the sponge filter is so dusty that suction does not return to 100%,
then we suggest that the filter be removed then rinsed under the faucet and allowed to dry for 24
hours by airing not near the fire or some high temperature objects before refitting into the vacuum.
This should be done once six months or when suction appears to be reduced obviously.
Important:
Please note that there is a safety switch inside the vacuum to prevent the unit from being run with
high vacuum rate. If the vacuum is too high ,the safety switch will be turned on. In this case, it can
minish the vacuum rate and protect the motor from being broken.
Note: The suction hole must be open, free of any obstructions at all times. Otherwise, the motor will
overheat and could become damaged.
Important:
All filters should be checked regularly for signs of damage, preferably after each cleaning task. The
filters must be replaced immediately if they become damaged. Always disconnect the vacuum from
the electrical outlet when checking the filters.
11