Bixpy BA-HHB-1001 Manual De Usuario Y Guía De Seguridad página 8

YOUR OUTBOARD POWER PACK
Your Outboard Power Pack is activated using the provided magnetic kill switch. Place the kill switch
on the front indentation of your Power Pack, near the LED indicators. Once your Power Pack
detects the magnet, it will activate your system within about 2 seconds. If you battery has any
charge, it will indicate its approximate charge level by lighting up the 6 LED lights. A full battery will
show all 6 LEDs lit. Each LED represents approximately 17% of the battery's capacity.
Once your Power Pack is activated and connected to your Thruster, you'll be able to run your
Thruster in 12 forward speeds and 3 reverse speeds using your Bixpy Remote. Use your right
forward button to move through the 12 forward speeds and the left button to move down through
the forward speeds and into the reverse speeds. Use the stop button for a complete stop
regardless of speed.
YOUR KILL SWITCH
The kill switch is there to protect you in case of an accident where you and your vessel are
separated. Always ensure that the kill switch is attached to you in some way. That way, if you and
your vessel part ways, the motor stops. Not wearing your Kill Switch can lead to serious injury or
death to you and those around you.
START WITHOUT YOUR REMOTE (Outboard Power Pack only).
If you lose, misplace or have a dead battery on your remote control, you can still start your Thruser
by tapping your kill switch on the Power Pack four times. Timing your taps to activate the Power
Pack is important. Watch this video to learn how to do this: www.bixpy.com/4taps. This features
starts and runs your Thruster at speed 5 forward only. Stop by removing the Kill Switch.
AUXILIARY POWER
The Bixpy Outboard Power Pack has one output for both 12V and 5V USB power. Use only Bixpy
connectors to power your phones, tablets and small 12V devices.
7
E