LEMAN POB126 Manual De Instrucciones página 21

Inspecting the carbon brushes (Fig 8)
The Motor employs carbon brushes which are consumable parts. When they become worn to or near the "wear
limit", it could result in motor trouble. The power tool must then be sent to an after-sales service agent.
When you have to replacement the carbon brushes by yourself, please following the order:
- Untight the two screws ST3.5x16 (19) and remove the top cover (6).
- Loosen and remove the two brush covers (17) on both sides of the motor housing.
- Remove the carbon brushes (18).
- After replacing the carbon brushes, reinstall and screw the two brush covers (17), and then the top cover (6).
CAUTION:
Repair, modification and inspection must be must be carried out by a LEMAN Authorized Service Center.
In the operation and maintenance of power tools, the safety regulations and standards prescribed in each country
must be observed.
Do not dispose of electric tools together with household waste material!
In observance of European Directive on waste electrical and electronic equipment and its
implementation in accordance with national law, electric tools that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.
GB
DISPOSAL
21