JOCCA 6641 Manual De Instrucciones página 8

14-E
appliance outdoors. Never leave the appliance exposed to clima-
tic agents such as rain, snow, sun, etc....
-This appliance is itended to be used only by adults. Do not allow
people not accustomed to this kind of appliances, handicapped
people or children to use this item.
-This product can also be used with an adapter, therefore before
connecting the appliance to the mains, check that the cable and
plug are in perfect conditions. Also check that the voltage indica-
ted on the appliance is valid for your electrical installation.
-If you detect that the power supply cable or the plug are dama-
ged, do not use the appliance or try to replace the cable yourself.
Go directly to the authorised JOCCA technical service where they
will replace it correctly for you.
-Do not immerse the appliance or any part of it in water or any
other liquid.
-Do not pull the cable to unplug the appliance from the mains,
always pull from the plug.
-If your appliance has been dropped or fallen into water or any
other liquid do not use it or try to repair it. Take it to the JOCCA
technical service.
-Do not immerse the appliance or any ypart of it in water or any
other liquid.
-For your safety and for the appliance to work correctly, always
use JOCCA spare parts and accessories.
-Do not move the appliance when it is in use.
-Use the appliance on a flat surface.
-This appliance will be completely switched off when it is unplug-
ged from the mains.
WARNING: Switch off the machine and unplug the adaptor in the
following cases:
-When carrying out any activity such as threading, changing the
needle or changing the bobbin.
-While changing parts or while sewing.
-When you finish using it.
-During a power cut.
-When using the machine, pay special attention to the needle and
to the balance wheel, never push the bobbin or the needle.
INSTRUCTIONS FOR USE
Warning! Before using the machine.
-Make sure that the button is in the OFF position. Insert the bat-
teries in the lower part of the machine in the correct position and
in the position indicated in the picture or connect the AC/DC adap-
tor in its corresponding socket and then to the power supply (not
included).
Indications to take into account:
-To use the machine either the ON switch can be used.
NOTE: Always disconnect and switch off the machine when not in
use.
HOW TO THREAD THE TOP THREAD (fig1)
-Lift up the presser foot lever and lift the needle by turning the
balance wheel following the arrow indicated on the same. Follow
the following instructions:
1.-Pull the bobbin holder in order to install the reel correctly.
2.-Pass the thread through the tension wheel.
3.-Lead the thread through guides 1,2,3,4 and 5. See drawing.
4.-Pass the thread through the hole of the needle from the front
side to the back side.
HOW TO START SEWING
1.-Lift the needle by turning the balance wheel clockwise. Lift up
the presser foot.
2.-Make sure that the end of the thread is placed needle
backwards at least 10 cm.
3.-Put the garment in place, hold it down with the presser foot and
lower the needle manually.
4.-Press the start button to the ON position and start sewing.
Slide the cloth with your hand. Slide the cloth slowly during the first
stitches.
IMPORTANT:
When finishing, lift up the needle manually, and in this way it will
not bend when taking the garment out; lift up the presser foot and
withdraw the garment. Then cut both threads at 10 cm. in length.
E-15