Zipper Maschinen ZI-HS7H Manual De Instrucciones página 27

2.14 Troubleshooting and Fault Clearance
Disconnect the machine from the power supply prior to any checks performed at the ma-
chine itself !
Problem
Motor does not start.
Wrong motor direc-
tion.
Splitter not movIng al-
though motor is running.
Splitter working, however,
with untypical noise and
vibration
2.15 Disposal
Do not dispose your ZI-HS7H in the residual waste! Contact your local authorities
for information about best available disposal possibilities in your area. Drain fuel
from the fuel tank completely before disposing the machine. Disaggregate the ma-
chine into its components before disposing them.
Possible Cause
 No power in wall socket  Check fuse box
 Extension cable defective Unplug, check and use new one, if
 Wrong supply, 400 V,
three-phase
t
 Switch defective
 Wrong polarity
 Valve not opened, caused
by loose connection
 Oil level too low
 Oil level too low
Remedy
 necessary
 5-pole plug with 1.5 mm diameter
 Have it checked by electrician
 Change polarity using a screwdriver
(electrician)
 Change polarity (electrician)
 Tighten loose parts
 Replenish oil
 Replenish oil
27