Ec Declaration Of Conformity - AL-KO Hydrocontrol Manual De Instrucciones

EN

EC declaration of conformity

We hereby declare that this product, in the form in which it is marketed,
meets the requirements of the harmonised EU guidelines,
EU safety standards, and the product-specific standards.
Product
Manometric Switch
Serial number
G3903905
Model
Hydrocontrol
Warranty
If any material or manufacturing defects are found during the statutory customer protection period, we will either repair or
replace the equipment, whichever we consider the more appropriate. This statutory period may vary according to the legisla-
tion in force in the country where the equipment was purchased.
Our warranty is valid only if:
„ The equipment has been used properly
„ The operating instructions have been followed
„ Genuine replacement parts have been used
The following are not covered by warranty:
„ Paint damage due to normal wear
„ Wear parts identified by a border XXX XXX (X) on the spare parts list
„ Combustion motors – these are covered by a separate warranty from the manufacturer concerned
To make a claim under warranty, please take this statement of warranty and proof of purchase to the nearest authorised
customer service centre. This warranty does not affect the usual statutory rights of the customer relative to the seller.
2
Manufacturer
AL-KO Geräte GmbH
Ichenhauser Str. 14
89359 KOETZ
DEUTSCHLAND
EU directives
2014/35/EU
2014/30/EU
2011/65/EU
The warranty is no longer valid if:
„ The equipment has been tampered with
„ Technical modifications have been made
„ The trimmer was not used for its intended purpose (for exa-
┌──────┐
└──────┘
Executive Officer
Andreas Hedrich
Ichenhauser Str. 14
89359 KOETZ
DEUTSCHLAND
Harmonised standards
EN 60335-1: 2012
EN 60335-2-41: 2012
EN 62233: 2008
EN 55014-1: 2012
EN 55014-2: 2016
EN 61000-3-2: 2014
EN 61000-3-3: 2014
Kötz, 19.01.2016
Wolfgang Hergeth, Managing Director
mple, used for commercial or communal applications)