Technical Data - Bosch GAS 25 Professional Manual Original

OBJ_BUCH-464-005.book Page 12 Tuesday, July 12, 2011 9:40 AM
12 | English
11 Dust bag
12 Folded filter
13 Motor protection filter
14 Level sensors
Accessories shown or described are not part of the standard deliv-
ery scope of the product. A complete overview of accessories can
be found in our accessories program.

Technical Data

All-Purpose Vacuum Cleaner
Article number
Rated power input
Frequency
Container volume (gross)
Net volume
Dust bag contents
Vacuum, max.*
Airflow, max.*
Suction capacity
Surface of folded filter
Weight according to
EPTA-Procedure 01/2003
Protection class
Degree of protection
* measured at the blower
The values given are valid for nominal voltages [U] of 230 V. For lower
voltage and models for specific countries, these values can vary.
Please observe the article number on the type plate of your vacuum
cleaner. The trade names of the individual vacuum cleaners may vary.
Noise Information
Measured values determined according to EN 60704.
Typically the A-weighted sound pressure level of the product
is less than 70 dB(A). Uncertainty K = 3 dB.
The noise level when working can exceed 80 dB(A).
Wear hearing protection!
Declaration of Conformity
We declare under our sole responsibility that the product de-
scribed under "Technical data" is in conformity with the fol-
lowing standards or standardization documents: EN 60335
and the directives 2006/42/EC, 2004/108/EC including
their amendments.
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
27.05.2011
1 609 929 V16 | (12.7.11)
Assembly
Before any work on the vacuum cleaner itself, pull the
mains plug.
Replacing/Inserting the Dust Bag (see figure A)
– Unlock the latches 10 and remove the vacuum lid 3.
– Pull off the full dust bag 11 from the connection flange to-
ward the rear. Close the opening of the dust bag by folding
down the lid. Remove the closed dust bag from the vacuum
GAS 25
cleaner.
Professional
– Slide the new dust bag 11 over the connection flange of the
0 601 979 1..
vacuum cleaner. Make sure that the full length of the dust
W 1200
bag 11 faces against the inner wall of the container 9. Reat-
tach the vacuum lid 3.
Hz 50/60
– Lock the latches 10.
l 25
For dry vacuuming operation, a dust bag 11 should be insert-
l 16
ed. When operating with a dust bag 11, the folded filter 12
l 9
clogs slower, the vacuuming performance is kept up longer
hPa 248
and the disposal of dust becomes easier.
3
m /h 220
Mounting the Vacuum Hose (see figure A)
W 316 (6 mbar)
Mount the vacuum hose 8 onto the hose connection piece 7
2
cm 4300
and turn it in clockwise direction to the stop.
Insert the extension tubes firmly into each other.
kg 11.8
Note: Bosch recommends using static-discharging hoses
/I
with a hose Ø of 19 or 35 mm.
IP 24
Operation
Starting Operation
Observe correct mains voltage! The voltage of the pow-
er source must agree with the voltage specified on the
nameplate of the vacuum cleaner. Equipment marked
with 230 V can also be operated with 220 V.
Switch the vacuum cleaner off immediately as soon as
foam or water comes out, and empty the container.
Otherwise, the vacuum cleaner can become damaged.
Symbols on the Mode Selector Switch
on
off
Switching On and Off
To start the operation of the vac, set the mode selector
switch 4 to on.
To switch off the vac, set the mode selector switch 4 to off.
Switching On
Switching Off
Electromagnetic filter cleaning
Operation with remote automatic switching
Bosch Power Tools