DeWalt DXSTA26CLB Manual De Instrucciones

JS PRODUCTS | 6445 MONTESSOURI STREET, LAS VEGAS, NV 89113
(APR18) Part No. 41599
Copyright © 2018 D
D WALT and the D WALT Logo are trademarks of the D
®
E E
Co., or an affiliate thereof and are used under license. The yellow/black color
scheme is a trademark for D
Definitions: Safety Guidelines
The definitions below describe the level of severity for each signal word. Please
read the manual and pay attention to these symbols.
WARNING: Indicates a potentially hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may
result in minor or moderate injury.
(Used without word) Indicates a safety related message.
NOTICE: Indicates a practice not related to personal injury which, if not avoided,
may result in property damage.
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY
D WALT TOOL, CALL US TOLL FREE AT: 1-844-377-8451
E
WARNING! Read and understand all
instructions.
and operating instructions.
carefully before assembling this storage rack and
save it for reference.
SAVE THESE INSTRUCTIONS
TECHNICAL SPECIFICATIONS
NOTE: These brackets are to be used with your D
DXST4500 Industrial Rack (not included).
DXSTA26CLB Copyright © 2018, D
WALT.
E
WALT Industrial Tool
E
WALT power tools & accessories.
E
This manual contains important safety
Please read this manual
WALT DSXT10000 or
E
Technical Specifications
Total Capacity per 2 Piece 6-Inch
Cantilever Bracket set
Capacity Per 6-Inch
Cantilever Bracket
Cantilever Arm Depth
GENERAL SAFETY
• Keep work area clean and dry.
• Use correct/recommended tools for the job.
• Never leave tools unattended.
• Never force a part into place.
• Wear safety apparel.
• Wear safety glasses/goggles.
• Never hang from the 6-inch Cantilever Bracket.
• Never crawl, sit, stand, or climb on the rack.
• Keep small parts away from children. Never leave small children unattended
while assembling.
• Always use common sense – your personal safety is your responsibility.
SPECIFIC SAFETY FOR WALL MOUNT BRACKET
WARNING:
Serious injury or death can occur from the rack tipping over.
To prevent this, the rack must be secured to the wall, especially in earthquake-
prone areas, or where surfaces are uneven, and where children and/or pets are
present. For added safety we recommend also mounting the rack to the floor
using D WALT part number DXSTA04MP (sold separately).
E
WARNING:
WEIGHT LIMITS FOR THIS 6-INCH
CANTILEVER BRACKET
• Maximum load per 6-inch cantilever arm is 50 lb (22.6 kg).
• Maximum combined load per 6-inch Cantilever Bracket set is 100 lb (45.3 kg).
• Immediately remove the load should there be separation between the
cantilever arm and the mounting bracket.
• Immediately remove the load should there be damage, bending or warping of
WALT
E
the rack uprights or the cantilever arms.
Parts List
No. Description
1 6-Inch Cantilever Bracket
2 Locking Pin
1
BEFORE YOU BEGIN:
• Read all instructions thoroughly.
• Remove all components from the box, and lay them on the floor in an
orderly fashion.
• Wear eye protection.
• Be cautious of sharp edges.
• Keep this information for further reference.
100 lb (45.3 kg)
*when weight is evenly distributed
50 lb (22.6 kg)
*when weight is evenly distributed
6" (15.2 cm)
NEVER EXCEED THE FOLLOWING
Qty.
2
READ ALL INSTRUCTIONS
2
4