Truma CP W Instrucciones De Uso página 6

Control Panel CP W
Operating instructions
Please be sure to read the instructions for installation
and use before attempting to connect and use this device!
Symbols used
Symbol indicates a possible hazard.
Safety instructions
To protect you from electrical shocks, injury or burns
the following basic safety principles must be observed
when using electrical devices. Please read and follow these
instructions before using the device.
Installation
Ensure that the devices are positioned safely and cannot fall
down or over. Always position the cables to ensure they do
not pose a tripping hazard. Do not expose electrical devices to
rain. Do not operate electrical devices in damp or wet environ-
ments. Do not operate electrical devices close to flammable
liquids or gases. Position the devices so that they are out of
the reach of children.
Protection against an electrical shock
Only operate devices whose casings and cables are undam-
aged. Ensure the cables are installed safely. Do not pull on the
cables.
Use
Do not use electrical devices for purposes other than those
stated by the manufacturer.
Repairs
Do not repair or modify the device. Please contact your dealer
or the Truma Service (see service manual or www.truma.com).
Accessories
Only use accessories and additional devices that are supplied
or recommended by the manufacturer.
6
Intended use
The control panel shows either the filling level of a freshwater
tank or a waste water tank. The filling level is called up via a
key and a filling sensor in the freshwater tank or via a measur-
ing sensor in the waste water tank. The display comprises a
three-color LED chain.
The device is designed for installation in caravans, campers
and boats.
Function description
CP W CP W
1/2 1/2
1/4 1/4
0
Made in Germany Made in Germany
1 Display (LED chain)
2 Key for querying the filling level
I = Fresh water tank
II = Waste water tank
Maintenance
Clean the panel with a dry and fluff-free cloth.
Any soiled and / or coated measuring rods (measuring sensors)
will falsify the display.
The sensor in the fresh water tanks should be removed as
required (at least once a year) and the measuring rods should
be cleaned.
The measuring sensor in the waste water tanks should be
cleaned as required (at least once a year).
1/1 1/1
3/4 3/4
Tank Tank
I II II
1
2