Wiring Diagram - Truma CP W Instrucciones De Uso

Wiring diagram

CP W CP W
1/4 1/4
0
Made in Germany Made in Germany
2 pol. 2 pol.
WH 1/1
BN 3/4
1
GN 1/2
YE 1/4
GY 0
BU = blue WH = white
PK = pink BN = brown
GN = green
YE = yellow
GY = grey
Supply battery (battery II)
The fuse must be attached close to the positive terminal
of the battery.
Waste water tank
Fresh water tank
8
1/1 1/1
3/4 3/4
1/2 1/2
Tank Tank
I II II
5 pol. 5 pol. 5 pol. 5 pol.
5 5
2 3
Installation of the filling level sensors
Waste water tank
The positions of the boreholes apply for symmetrical
tanks. The volume of non-symmetrical tanks needs to be
determined.
– Establish the height of the
tank (external dimensions).
– Establish and mark the posi-
tion of the 5 boreholes for
the sensors (1/4 H).
– Drill 5 holes with a diameter
of 9.5 – 10 mm into the
waste water tank.
– Smooth down the edges of
the boreholes.
– Coat the screws with seal-
ing compound or an elastic
adhesive.
– Assemble the measuring
sensors (1 wire of the 5-wire
line per measuring sensor).
– Tighten the screws by hand.
– Place each measuring sen-
sor into a borehole and
tighten with a screwdriver.
The edge of the rubber
seal is pressed against
the tank wall. The rubber
bulges inside thereby sealing
the borehole.