Tabla de contenido
Publicidad
ENGLISH
16
1.5 mm2. Use of extension cables of different length
and cross-section and also of adapters and multiple
sockets should be avoided.
Check the cable and/or socket for damages before
the appliance putting into operation.
Defective cable or plug may cause electric shock.
Do not pull the service cable to pull the plug out of
socket.
WARNING The power cut-off should always be in the
"off" position when the machine is left unattended.
Do not expose yourself or other persons without pro-
tection to electric arc or hot metal. Spraying welding
pearls may cause burns.
A suitable welding shield, protective clothes and
protective gloves to be worn at all times.
Long-term inhalation of welding gases may be harm-
ful to your health.
Work with an exhaust system or in well ventilated
spaces. Avoid direct inhalation of gases.
Contact with the hose bundle nozzle and the material
being processed may cause burns. Special welding
gloves to be worn at all times.
Let the hose bundle nozzle and the material being
processed cool down after being operated.
Long-term working with the appliance may damage
hearing. Hearing protection to be used at all times.
Welder may only be used on a flat surface and with a
properly secured gas bottle.
Make sure the welding smoke is exhausted or the
place of welding ventilated well.
Hot slag and sparks may cause fire or explosion. Never
use the appliance in a flammable environment.
Wood, sawdust, „varnishes", petrol, kerosine, natural
gas, acetylene, propane and similar flammable
materials must be removed from the place of work
and the surrounding area or protected against sparks
flying away.
To extinguish fire, a suitable fire extinguisher must be
made ready nearby.
No welding or cutting on closed vessels and pipes.
No welding or cutting on vessels and pipes if they
are open, containing materials able to explode due
to heat or moisture or able to cause other dangerous
reactions.
WARNING! Never use the welder to defrost frozen
pipes.
Do not expose the appliance to rain and do not use it
in wet or moisture conditions.
Specified Conditions Of Use
The plasma cutter with constant voltage characte-
ristic may only be used to cut electrically conductive
metals using air.
Only use the flame-cutting torch supplied.
Ambient temperature -10 °C - +40 °C
Relative air humidity max. 50 % (40 °C), 90% (20 °C)
Altitude above sea level max. 1000 m
The ambient environment must be free from
abnormal amounts of dust, acids, corrosive gases or
substances.
Respecting technical data and safety precautions.
Do not use this product in any other way as stated
for normal use. Not observing general regulations
in force and instructions from this manual does not
make the manufacturer liable for damages.
Emergency procedure
Conduct a first-aid procedure adequate to the injury
and summon qualified medical attendance as quickly
as possible. Protect the injured person from further
harm and calm them down. If you seek help, state the
following pieces of information: 1. Accident site, 2.
Accident type, 3. Number of injured persons, 4. Injury
type(s)
Symbols
WARNING/CAUTION!
WARNING - Read the operating instruc-
tions to reduce the risk of injury.
Wear eye protective goggles !
Special welding gloves to be worn at all
times.
Wear safety cut through resistant shoes
with safety sole and steel toe !
Protective apron to be used
Unplug the machine before any work
on it.
Warning against dangerous electric
voltage
Keep dry at all times. Never expose tool
to rain.
Any damaged or disposed electric or
electronic devices must be delivered to
appropriate collection centres.
CE marking
Publicidad
Tabla de contenido
