Technical Specifications; Inspection - Auxilab Nahita blue Manual De Instrucciones

6. TECHNICAL SPECIFICATIONS

Power supply
Input 100-240 V AC; 1000 mA; 50-60Hz
Output 24 V DC; 24 W.LPS; 50-60 Hz
Agitador
Operating voltage
Power consumption, normal operation
Power consumption, standby operation
Motor-output power
Drive
Speed
Orbital diameter
Shaking motion
Timer
Mode seconds
Mode minutes
Mode hours
Mode continuous
Display
Environ. temperature of use
Environ. relative humidity
Protection grade
Contamination
Overvoltage category
Operation at terrestrial altitude
Dimensions
Weight
Max. Shaking weight
Instruction manual 50681022
24 V DC
20 W
2 W
8 W
Brushless
300-3000 rpm
4.5 mm
Orbital
1-59 s
1-59:99 min
1-24 h
Continuous operation
LCD
5-40ºC
80% RH
IP21 (according to DIN EN 60529)
Level 2
II
max. 2000 m
210x150x65 mm
2.5 Kg
0.5 Kg (with attachment)
Pag. 14 Version 1 April-2015
ENGLISH
The feet of the equipment must be clean and not damaged.
If the shaking movement of the equipment increases (resonance), reduce the speed or
pass through the critical phase as quickly as possible.
Reduce the speed if:
• The liquid splashes out of the vessel because the speed is too high.
• The equipment does not operate smoothly.
• The equipment moves because of dynamic forces.
Secure firmly the attachments and vessels in the corresponding place; otherwise the
vessel could be damaged or projected out.
Check the equipment and accessories before each use. Never use damaged components.
Place one single vessel in the center or several vessels evenly spread out.
Vessels with sharped edges cause wear debris on the attachments.
Beware the risk of:
• Flammable materials
• Glass breakage as a result of shaking mechanical forces.
Only process material that will not react dangerously with the extra energy produced
during shaking. This also applies to any extra energy produced by other methods, as for
example light exposure.
Do not use the equipment in explosive atmospheres, with hazardous substances or
under water.
Safe operation is only guaranteed with the accessories described on the "Supplied
accessories" chapter.
Always disconnect the equipment before fitting accessories.
The appliance does not start up again automatically following a cut in the power supply.
Protect the equipment and accessories from knocks and impacts.
The equipment may heat up during use.
Non-authorized personnel is not allowed to disassemble and repair this machine. If the
equipment presents a problem, contact to your distributor.
Keep away from high magnetic field.

3. INSPECTION

Unpack the equipment carefully and check for any damages which may have arisen
during transport. If it happens, please contact your distributor.
Note: If there is any apparent damage on the equipment, do not plug it into the power line.
Instruction manual 50681022
ENGLISH
Pag. 11 Version 1 April-2015