Safety Instructions; General Guidelines; User Manual - HQ-Power VDSCO1 Manual Del Usuario

Filtro activo divisor –estéreo de 2 vías / mono de 3 vías
Ocultar thumbs Ver también para VDSCO1:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

1.
Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device should be returned to your
distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing HQPower™! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't install or use it and contact your dealer.
The VDSCO1 is a high-quality 2-way stereo or 3-way mono crossover using 12 dB/octave Butterworth filters
and a 40 Hz high-pass filter.
2.

Safety Instructions

Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Keep this device away from rain and moisture.
Unplug the mains lead before opening the housing.
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
A qualified technician shall install and service this device.
Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the
device against damage by leaving it switched off until it has reached room temperature.
This device falls under protection class I. It is therefore essential that the device be earthed. Have a
qualified person carry out the electric connection.
Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if
necessary.
Always disconnect mains power when device not in use or when servicing or maintenance activities are
performed. Handle the power cord by the plug only.
Keep this device away from splashing and dripping liquids. Never put objects filled with liquids on top of or
close to the device.
Damage caused by user modifications to the device is not covered by the warranty.
Keep this device away from children and unauthorized users.
3.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
This device is designed for professional use on stage, in discos, theatres, etc. The device shall only be used
indoors with an alternating current of max. 230 VAC, 50 Hz.
Do not shake the device. Avoid brute force when installing or operating the device.
Select a location where the device is protected against extreme heat.
Familiarise yourself with the functions of the device before actually using it. Do not allow operation by
unqualified people. Any damage that may occur will most probably be due to unprofessional use of the
device.
All modifications of the device are forbidden for safety reasons.
Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
Use the original packaging if the device is to be transported.
Keep this manual for future reference.
V. 02 – 17/09/2013
VDSCO1

USER MANUAL

2
©Velleman nv

Publicidad

Tabla de contenido
loading

Tabla de contenido