Safety Regulations - OP TUBOMATIC H54 EL Manual De Uso

OP S.r.l.
Via Serpente 97 25131 Brescia Italia Tel. +39.030.3580401 Fax. +39.030.3580838
________________________________________________________________________________________________

SAFETY REGULATIONS

1. Always make sure that the machine is placed on a stable, safe surface and that it is
not causing vibrations that, in addition to being bothersome and useless, may cause
malfunctions.
2. Leave enough room in the work zone.
3. The manufacturer is not liable for any damage caused by negligence.
4. NEVER USE the equipment before reading the user manual and
5.
6. Crimping operations are safe provided the regulations given below are
complied with.
7. CAUTION ! It is absolutely essential that all work is carried out
8. Never attempt to use the machine above the permitted working pressures; this might
cause serious danger to the operator
9. This manual must be given to the operator and kept. The proprietor of the equipment
is responsible for it. Ensure that the operator is aware of his responsibilities.
10. Never remove or tamper with guards.
11. Before connecting to the power supply, make sure that there is adequate protection
upstream of the connection against overloads and short circuits (it is advisable to have
protection against excessive undervoltage as well).
12. Check that the supply voltage and frequency correspond to the rating on the machine's
rating plate.
13. Use only cables, plugs and extension cables that comply with CEI standards; keep the
power cable far from the work zone.
14. Always remove the plug from the socket
Operations of maintenance, as well as repairs, should be performed by specialised
personnel.
15. Make sure that hoses are always crimped in safety conditions.
UNDERSTANDING ITS CONTENTS
CAUTION ! If improperly used, the equipment may be dangerous and may cause
injury to parts of the body, which must never come within the range of moving
parts.
16. Use gloves and adequate personal protection (gloves, appropriate
clothing, etc.).
.
, before performing any work on the machine.
35
by one operator only
E
N
G
L
I
S
H