Standard Accessories; Battery Removal/Installation - HIKOKI DS 7DF Instrucciones De Manejo

Taladro atornillador a bateria
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
12. When mounting a bit into the keyless chuck, tighten
the sleeve adequately. If the sleeve is not tight, the
bit may slip or come off, causing injury.
SPECIFICATIONS
POWER TOOL
Model
No-load speed
Drilling
Capacity
Driving
Rechargeable battery
Weight
CHARGER
Model
Charging voltage
Weight

STANDARD ACCESSORIES

1 Plus driver bit (No. 2 55L) ........ 1
2 Charger (UC7SB or UC7SD) ........... 1
DS7DF
3 Plastic case ....................................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
1. Battery (FEB7S, EB712S)
Optional accessories are subject to change without notice.
APPLICATIONS
Driving and removing of machine screws, wood
screws, tapping screws, etc.
Drilling of various metals.
Drilling of various woods.
Wood
(Thickness 18mm)
Metal
(Thickness 1.6mm)
Machine screw
Wood screw
UC7SB
UC7SD
7.2 V
1.0 kg
1.1 kg
0 – 600 min
15 mm
Steel: 10 mm,
Aluminum: 10 mm
5.1 mm (diameter) × 32 mm (length)
(Requires a pilot hole)
FEB7S: Ni-Cd 7.2 V
(1.4 Ah, 6 cells)
1.3 kg

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery. (See Figs. 1 and 2)
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its direction. (See
Fig. 2)
CHARGING
Before using the driver drill, charge the battery as follows.
1. Insert the battery into the charger.
Position the battery so that the nameplate faces
toward the nameplate of the charger and press in the
battery until it comes into contact with the bottom
surface. (See Figs. 1 and 3)
2. Connect the charger power cord to the receptacle.
Connecting the power cord will turn on the charger
(the pilot lamp lights up).
CAUTION
If the pilot lamp does not light up, pull out the
power cord from the receptacle and check the
battery mounting condition.
(1) Regarding recharging time
Depending on the combination of the charger and
batteries, the charging time will become as shown in
Table 1.
English
DS7DF
–1
6 mm
EB712S: Ni-Cd 7.2 V
(1.2 Ah, 6 cells)
1.2 kg
5

Publicidad

Tabla de contenido
loading

Tabla de contenido