Instructions For Use - Metabo 31 599 Instrucciones De Manejo

ENGLISH

Instructions for Use

Bench-Mounting Stand 31 599
For stationary use (to operate as surface planers) the Metabo Planers Ho 0882,
Ho 0883* and Ho E 0983* can be fitted on the 31 599 Bench-mounting stand.
* With the Ho 0883 and Ho E 0983, insert the support plate as described.
Scope of delivery
Finger guard
First of all the finger guard (6), which is
supplied separately, should be fitted to the
upright (2) on the bench-mounting stand.
To do this, remove the spring cotter pin from
the pivot on the finger guard, then insert the
guard with the pivot into the hole in the upright.
The washer (4) should be situated between
the cylindrical part of the finger guard and the
upright. Secure the pivot on the guard by
means of the spring cotter pin.
During surface planing the finger guard covers
the cutter block of the planer that is fitted to
the stand. For rebating the finger guard is
removed. For all surface planing work the
finger guard must be fitted to the stand.
4
To fix the stand on the workbench
The bench-mounting stand can be fixed on the
workbench using two Metabo Screw clamps
27 107 or suitable G-clamps.
Fitting the planer to the stand
If the planer is connected to the power supply:
Pull the plug from the socket.
Remove the rebating depth stop from the tool.
To prevent losing the rebating depth stop (1)
of the planer which is not required, it can be
screwed to the stand.
Planer Ho 0882:
Remove the support plate (10) from the
stand.Place the tool with its housing
on the two pillars (9) on the stand.
Planers Ho 0883 and Ho E 0983:
The support plate (10) must be inserted in
its bracket in the stand as far as the stop.
Fit the tool with its handle between the
pillars (9).
10
Ho 0882
Ho 0883,
Ho E 0983
Then screw the thumbscrew (3) into the
tapped hole in the planer provided for the
rebating depth stop.