Electronic Control; Control Panel Description; Programming Time Functions; Setting The Time Of Day - FULGOR F1SP24 Serie Manual De Uso

Control panel description

The oven control panel is made with one display and two
knobs.
• Time & Temperature display.
• Time & Temperature knob (Push & Shuttle).
• Mode (oven functions) knob.
The push & shuttle knob is mainly for clock or temperature
setting and automatic time functions programming. Select the
desired item by pushing the knob.
MODE

Programming time functions

At every power-up, the control shows the time of day blinking,
set at 12:00 as the initial value. The time increases every
AM
minute. The only possible action is the "Clock Regulation", all
other oven operations are inhibited.
In general, turn the Temp/Time selector left or right in order to
edit the values and modify them by steps; hold the knob on the
left or right to fasten the decrease/increase operations.

Setting the time of day

The time of day is always displayed in the 12:00
format. Hours and minutes are set separately. In order to set the
time of day, mode selector must be in ZERO position, the -/+
knob acts on the time of day by default.
• Turn the selector left/right, the hours flash.
• Modify the flashing hours value turning the selector left/right.
• Push the Temp&Time selector to switch back and forth
between hours and minutes.
• Modify the flashing minutes turning left/right.
• After a few seconds the whole time of day value starts
flashing: wait until the new time of day is steady.
Push the knob to toggle between the time of day and the
minute minder and check the set values. The clock is selected
by default while the symbol appears when the minute
minder is displayed.

Setting the minute minder

When the
order to set the timer value.
The standard value is 30 minutes, it's possible to modify it in
the range between 0 and 240 minutes.
This timer has no influence on the oven activities and can be
set also when the oven is off. The time of day is displayed with
priority in any case, the
is active.
When the time expires, the
sounds a warning sequence (two short beeps repeated every
3 seconds) to recall the user attention. Push the knob to stop it.
The buzzer stops in any case after a time-out.

Buzzer volume

The buzzer volume can be set turning the Time&Temp knob
to the left when the control is in light mode. At any detents
the buzzer sounds a double beep, selecting the volume out
of three available levels. The buzzer must always be silent
TEMP & TIME
between 22:00 and 8:00.

Temperature Unit Measurement

To select Fahrenheit or Celsius press +/- knob twice, when the
display shows F or C turn +/- knob to change the unit on
measurement, press again +/- knob to confirm.
hours
AM/PM

5 - Electronic control

symbol is displayed, turn the knob left/right in
symbol shows the minute minder
symbol flashes and the buzzer
EN
7