Braun 7 serie Manual De Istrucciones página 15

Ocultar thumbs Ver también para 7 serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30
Description
Clean&Renew station
1
Cleaning fluid display
2
Lift button for cartridge exchange
3
Station-to-shaver contacts
4
Start button
5
Cleaning program indicators
6
Station power socket
7
Cleaning cartridge
Shaver
8
Foil & Cutter cassette
9
Cassette release button
10 Shaver head lock switch
Before shaving
Prior to first use you must connect the shaver to an electrical outlet using the special
cord set (20) or alternatively proceed as below.
Installing the Clean&Renew station
• Press the lift button (2) to open the housing.
• Hold the cleaning cartridge (7) down on a flat, stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge into the base of the station as far as it will go.
• Slowly close the housing by pushing it down until it locks.
• Using the special cord set (20), connect the station power socket (6) to an electrical
outlet.
The cleaning fluid display (1) will show how much fluid is in the cartridge:
up to 30 cleaning cycles available
up to 7 cleaning cycles remaining
new cartridge required
Charging and cleaning the shaver
Insert the shaver head with the front showing and released head lock (10) into the
Clean&Renew. The contacts (17) on the back of the shaver will align with the contacts (3)
in the cleaning station. Important: The shaver needs to be dry and free from any
foam or soap residue!
If required, the Clean&Renew station will automatically charge the shaver. The hygiene
status of the shaver will also be analyzed and one of the following cleaning program
indicators (5) will light up:
shaver is clean
short economical cleaning required
normal level of cleaning required
high intensive cleaning required
11 Pop-out long hair trimmer
12 On/off switch
13 – setting button (sensitive)
14 + setting button (intensive)
15 Reset button
16 Shaver display
16a Charging lights (green)
16b Low -charge light (red)
16c Replacement symbol
17 Shaver-to-station contacts
18 Shaver power socket
19 Travel case
20 Special cord set (design can differ)
15

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

7880cc7867cc7865cc7850cc5697

Tabla de contenido