Voltage Commutation - Unold 87415 Manual De Instrucciones

24. The curling brush is very hot after use. Handle with care to avoid
burns.
25. Disconnect the appliance before depositing.
26. The appliance features overheat protection. To avoid damage,
the appliance automatically switches of when operated too long.
After an adequate cool-off time, the appliance may be operated
again.
27. After use and before cleaning always switch the appliance off,
disconnect the plug from the wall socket and let it cool off.
28. As long as the appliance is connected to the main power supply,
it constitutes a potential danger near water.
29. Do not stick any objects into the appliance, as possible damage
may cause electric shock.
30. Use the appliance only for the intended purposes indicated in
this manual.
31. Do not use the appliance with accessories of other manufacturers
or brands, to prevent damage.
32. Never open the casing of the appliance to prevent electric shock.
33. Check the plug and lead cable regularly for wear and tear. In
case the lead cable or other parts present damage, please send
the appliance to our after-sales service for inspection and repair.
Unauthorised repairs can constitute serious risks for the user
and void the warranty. If the lead cable is damaged, it must
be replaced by the manufacturer or its after-sales service or a
similarly qualified person in order to avoid any hazard.
Caution! The appliance is very hot during and after operation!
Never open the housing of the appliance. There is danger of
electric shock.
For safety reasons never use the appliance close to or in a
bathtub or washbasin or any other container filled with water.
If the appliance is used in a bathroom, unplug it from the wall
socket after use, since nearby water presents a danger even
when the appliance is switched off.
The manufacturer will not be liable in the event of incorrect assembly, improper or incorrect use or if
repairs are carried out by unauthorized third parties.

VOLTAGE COMMUTATION

Before connecting the appliance please check if the voltage selector is adjusted to the right voltage
(220–240/115 V~). To change the selection a coin may be used.
Copyright UNOLD AG | www.unold.de
15