Asystems DMP801 Manual Del Usuario página 14

DMP801
ALC – Auto Level Control
An autoleveler will allow users to dynamically change the level of an input or output signal to match a predefined level
set by the user� The autolevel function can be activated for each individual mix in the matrix pages� The settings for these
autolevelers can be found within this ALC menu�
In Target: The target level setting allows users to select the desired signal level for their autoleveler� All signals that are
processed by the autoleveler will essentially aim for the target level�
Below Target: The below target threshold of the autoleveler is the point at which the autoleveler will kick in� Signals
below the threshold will not be affected, but signals above will be have their gain increased�
Ratio: The ratio is the input level change in decibels to the output level change in decibels�
Increase Gain: The increase gain determines the amount that the signal can be increased to meet the target level� This
helps prevent sudden, alarming changes in audio level�
Decrease Gain: The decrease gain works the same as the decrease gain, but in reverse� It determines the amount a
signal can be cut�
Hold Time: This determines the time the ALC will remain engaged after the signal falls back below the determined
threshold�
14
English