Asystems DMP801 Manual Del Usuario página 15

DMP801
Compressor/Limiter
This menu allows compressors and limiters to be applied to the channel output
Limiter Threshold: This control determines the threshold for the limiter function� This means that no signal will surpass
the selected threshold, being 'compressed' at a ratio of infinity:1.
Compressor Threshold: Use this control to set the threshold of the compressor function� Any signals that surpass the
selected threshold will be compressed at the selected ratio�
Compressor Ratio: This control can be used to set the ratio for the compressor� The ratio is expressed as
<input>:<output>�
Compressor Attack: This control adjusts the attack time of the compressor, essentially determining the time taken for
the compressor to kick in after it passes the selected threshold�
Compressor Release: The release control determines the time the DMP801 will wait before disengaging the compressor
when the signal bypasses the selected threshold�
Side Chain HPF: This allows users to set a high pass filter on these channels to essentially help rid these channels of
low-frequency noise�
15
English