En - Installation Instructions - Kermi ZB04620001 Instrucciones De Montaje

Durch die Bohrungen der Standkonsolenfüße die
Bohrlöcher anreißen (Abb. 16).
Den Heizkörper entfernen und die Löcher an den ge-
kennzeichneten Stellen bohren (Abb. 17).
Den Heizkörper in Position bringen, aus richten und
mit geeigneten Dübeln und Schrauben (4 Schrauben
pro Konsole, max. Ø 10 mm) am Boden befestigen
(Abb. 18).
Heizkörper horizontal
zu verstellenden Seite den Gewindestift (9)
und die Sechskantmutter (8) lösen. Heiz-
körper ausrichten.
stift (9) und die Sechskantmutter (8) wieder festziehen
(Abb. 19).
Bodenabstand korrigieren: An beiden Seiten den Ge-
windestift (9) und die Sechkant-mutter (8) lösen und
den Abstand korrigieren sowie horizontal ausrichten.
Danach die Gewindestifte (9) und die Sechskantmut-
tern (8) wieder festziehen (Abb. 19).
Die Verpackung wieder vollständig über den Heizkör-
per ziehen (Abb. 20).
EN – Installation instructions
Permitted use
The stand bracket is intended solely for fixing FTP, PTP and
PLP Kermi steel panel radiators type 20-33 and of length
500-2600 for application class 2 on finished flooring.
Any other use is considered improper and therefore im-
permissible!
Maintenance and cleaning
The stand bracket does not require special maintenance.
Only clean the stand brackets with mild, nonabrasive
commercially available cleaners.
Complaint
Please contact your specialist in case of damage!
Allow only a specialist to carry out installation and
repairs, as otherwise your legal right to a warranty
claim for defects in material or workmanship will be
invalidated.
Disposal
Packaging and any parts that are not needed should
be recycled or disposed of properly. Observe local re-
gulations.
4
ausrichten: Bei der
Danach den Gewinde-
EN – Installation instructions
The stand brackets may be installed only by a heating
engineer.
They may only be used in closed heating systems.
Safety information
Read the instruction installations thoroughly prior to
installation.
Observe all information regarding installation loca-
tion, technical data, limitations on use, floor condition
and distance from wall.
After installation, pass the instructions on to the end
user.
Only store and transport the installation material in
the protective packaging.
WARNING
Risk of injury!
Note the weight of the radiator (see manufacturer's
data).
At 25 kg and above, the work should be carried out
with lifting equipment or by several persons.
Packaging and scope of delivery
Remove radiator packaging on the bottom and rear
side in the area of the bottom lugs (Fig. 2)
Inspect the contents of the stand bracket package for
completeness and damage.
1
4
2
3
Figure stand bracket (SK)
5
6
4
3
7
8
9