Adjusting The Sliding Guides For The Doors Of The Sliding Door Cabinet; Adjusting The Mobility Unit (1-4) And Push Handle (5) On Modular Cabinets Up To 1200 Mm In Height - Garant Group 95 Manual De Instrucciones

4.2.3

Adjusting the sliding guides for the doors of the sliding door cabinet

The sliding door runs in the bottom rail on 2 roller bearings and is guided
in the top rail with 2 plastic sliding guides. Roller bearings (1) and plastic
sliding guides (2) can be replaced using a 17 mm ring spanner.
If misuse or overloading lead to nasty scraping or squeaking noises, the
sliding guides (2) can be adjusted using a 17 mm ring spanner.
4.2.4 Adjusting the mobility unit (1-4) and push handle (5) on modular cabi-
nets up to 1200 mm in height
Insert both chassis stretchers (1) into the recesses in the fl oor of the cabinet.
Bolt a pair of ball bearing castors (2) and fi xed wheels (3) through each of
the stretchers and into the cabinet shell, using the fi xings supplied. A
mobility unit includes a push handle. See below for assembly.
Please note especially: Mobility units may not be fi tted to cabinets taller
than 1200 mm high. The risk of tipping is greater if the cabinet is fi tted with
a pull out shelf or drawer. a pull-out shelf or drawer.
Note: The handle should be fi tted on the same side as the castors.
www.hoff mann-group.com
DE
DE DE
EN
FR FR
FR
IT IT
IT
ES ES
ES
33