Description - Echo CSG-7410ES Manual De Instrucciones

1. Front handle (for the left hand) - Support handle locat-
ed at the front of the engine housing.
2. Wheel guard - A wheel guard which is intended to pro-
tect the operator from wheel contact, and also direct de-
bris away from the operator.
3. Cutting wheel - Serving as a cutting tool.
4. Wheel mounting bolt -Bolt that secures the flange.
5. Cutter flange - Part that secures the cutting wheel.
6. Fuel tank cap - For closing the fuel tank.
7. Momentary stop switch - Button for momentarily
shorting ignition voltage, causing the engine to stop.
This is NOT an ON/OFF Ignition switch.
8. Throttle trigger - Device activated by the operator's fin-
ger, for controlling the engine speed.
9. Throttle trigger lockout - A safety lever which must be
depressed before the throttle trigger can be activated in
order to prevent the accidental operation of the throttle
trigger.
10. Choke control knob - Device for enriching the fuel/air
mixture in the carburettor to aid cold starting. Also acti-
vates fast idle throttle latch.
11. Starter grip - Pull handle slowly until starter engages
then quickly and firmly. When engine starts, return han-
dle slowly. Do not let handle snap back or damage to
unit will occur.

Description

12. Air cleaner cover - Covers air cleaner.
13. Rear handle (for the right hand) - Support handle lo-
cated towards the rear of the engine housing.
14. Water kit - Supplies water while cutting to keep dust
from scattering.
15. Clutch cover - Protective belt and clutch when the en-
gine cut-off saw is in use.
16. Arm mounting bolts - Secures the cut-off saw.
17. Pulley Cover - Protects the belt and pulley.
18. Wheel guard locking knob - For use when changing
the angle of the wheel guard.
19. Wheel guard knob - Grip and move this knob when
changing the angle of the wheel guard.
20. Spark arrestor muffler - The spark arrestor muffler
controls the exhaust noise and prevents hot, glowing
particles of carbon from leaving the muffler.
21. Decompression device - Device for lowering the com-
pression in the cylinder, to aid starting.
22. Type and serial number
15
Description