Automatic Switch-Off/Economy Mode; Taring Weight Display (Tare); Use Of Differential Display Function - Seca 383 Manual De Instrucciones

– The kg or lbs display lights up.

Automatic switch-off/economy mode

The scale remains ready for weighing for approx. 20 seconds after being switched on.
Once weighing has been performed, the value is displayed for approx. 2 minutes until the
scale switches off automatically.

Taring weight display (TARE)

The tare function is useful if an additional weight (such as cloths or a pad on the weighing
surface) are to be ignored in the weighing result. Proceed as follows:
– Place the additional weight on the scale
and activate the Tare function by de-
pressing and holding the HOLD/TARE
key for 2 seconds.
The display of the scale is now reset to
" " and a normal weighing operation
0
can begin. The note "TARE" appears.
– You can now perform as many weigh-
ing operations as you like with this addi-
tional weight.
– TARA is deactivated by pressing the
button HOLD/TARE once again, or by
switching the scales off.
Important!
The maximum additional weight is 20 kg. The maximum weight which can be displayed
is reduced by the weight of the objects already placed on the scale.

Use of differential display function

This function can be used to store an individual weight value and then use that value to
form a difference - to detect the amount of milk ingested during breastfeeding, for exam-
ple, or to see how a particular baby's weight has increased since it was last weighed.
– To store the weight value, press the
STORE key for approx. 2 seconds after
the weighing operation is complete. The
note appears. The weight value is
ST0
now saved and will also remain stored
once the scale is switched off.
– With a subsequent weighing operation
it is then possible to switch the display
over to differential display, i.e. display of
current value less saved value, by briefly
pressing the STORE button.
Model 383 13
GB