Automatic switch-off/economy mode
The scale automatically detects whether it is being operated on rechargeable batteries
alone or whether it is connected to the mains.
– With rechargeable battery operation: automatic shut-down after 3 minutes.
– With mains operation: shut-down only via keypad.
Taring weight display (TARE)
Proceed as follows:
– Press the Start key with no load on the
scale.
– First stand on the scales yourself with-
out the additional weight and activate
the Tare function by pressing the TARE
key.
The display is reset to zero,
in the display until weight is detected to
be stable. Only then is the Tare function
fully activated. The note "NET" appears.
– Now take the additional load onto the
scale. You can leave the scale to do so,
in which case
----
The scale determines the weight of the
additional load. You can now perform
as many weighing operations as you
like.
– Press the key again to deactivate the
Tare function; the scale is then back in
normal weighing mode and the tare val-
ue has been erased.
– The tare value is likewise erased by the
scale being switched off.
Store weight value (HOLD)
You can also continue displaying the weight determined once the load has been removed.
This makes it possible to look after a patient first, before having to note the weight:
– Press the HOLD key whilst the load is
on the scale.
"HOLD" appears in the digital display. The
display starts to flash, showing that the
scale is checking the stability of the weight
values. Only once stability prevails is the
displayed value stored. The value is stored
until the scale switches off automatically.
The triangle with the exclamation mark in-
dicates that this frozen display is an addi-
tional facility which is not subject to
calibration.
26
flashes
0. 0 0
appears.