Using The Remote Control - Sharp AY -X08BE Manual De Instrucciones

USING THE REMOTE CONTROL

LOADING BATTERIES
1
Remove the remote control
cover.
2
Insert batteries in the compart-
ment, making sure the ± and
— polarities are correctly
aligned.
• The display indicates "AM
6:00" when batteries are prop-
erly installed.
3
Reinstall the cover.
NOTES:
• The battery life is approximately one year in normal use.
• When you replace the batteries, always change both batteries, and make sure
they are the same type.
• If the remote control does not operate properly after replacing the batteries, take
out the batteries and reinstall them again after 30 seconds.
• If you will not be using the unit for a long time, remove the batteries from the
remote control.
HOW TO USE THE REMOTE CONTROL
Point the remote control towards
the unit's signal receiver window
and press the desired button. The
unit generates a beep when it re-
ceives the signal.
• Make sure there is no curtain or other
object between the remote control and
the unit.
• The remote control can send signals
from up to 7 metres away.
Use two size-AAA (R03) batteries.
E-6
Remote control
cover
+
-
-
+