Battery Replacement - Telcoma Automations FM400 Taxi Instrucciones De Uso

FAMILY LOADING FUNCTION (NOIRE TAXI only)
The "family" of the NOIRE programmer can be loaded into the NOIRE TAXI
radio remote control.
Hold down key 3 and at the same time press key 1 four times.
Then release key 1. The central LED will start to flash.
Place the remote control above the programmer and start the
FAMILY loading procedure from the programmer.
If the procedure is completed successfully, the message "Family Inserted"
will appear on the programmer display.
The same procedure can be used to delete the family.
FAMILY LOADING FUNCTION (FM400 TAXI only)
Open the transmitter battery compartment. Connect the programmer cable
to the contacts on the transmitter then start the family loading procedure.

BATTERY REPLACEMENT

To replace the battery, open the battery compartment and remove the
battery with the aid of a tool (for example the tip of a pen). Fit the new
battery taking care to observe polarity. See fig. 2 on page 2.
F1 F2 F3 F4
1 2 3 P
4 5 6 C
7 8 9 0
GB
25