Mondial VIP CARE TRAVEL IRON Manual De Instrucciones página 8

Choice of water
This iron can be used with normal tap water.
˃
˃ If the water in your area is particularly hard, it is advisable to use distilled or
demineralized water.
Do not use chemically descaled water or any other liquids for refilling.
˃
How to fill in water
˃ Set the steam control knob(3) to "0" and the temperature control dial(6) to "OFF".
Unplug the iron from the wall outlet, and wait for the iron to cool down.
˃
Pour water into the water inlet (2):
˃
- Fill up to the maximum level "MAX" of the water tank.
Temperature control setting
Always check garment label for ironing instructions before ironing garment.
˃
˃ If the ironing instructions are missing, then the table below may help you.
˃ First you should sort the laundry: Wool with wool, Cotton with cotton etc. Start
ironing the fabrics requiring the lowest temperature and progress to the higher
ones because the iron heats up quicker than it cools down.
If the fabric consist of various kinds of fibres (e.g. cotton with polyester ) you must
˃
always select the ironing temperature for the material with the lowest advised
temperature.
ETIQUETA
SINTÉTICO
SINTÉTICO
SINTÉTICO
SEDA
LANA
ALGODÓN
LINO
14 UK
TIPO DE TEJIDO MATERIALES
ACRÍLICO
POLIPROPILENO
POLIURETANO
ACETATO
TRIACETATO
POLIAMIDA (NYLON)
POLIÉSTER
VISCOSA (RAYÓN)
SEDA
LANA
ALGODÓN
LINO
Setting the temperature
Insert the plug in the wall socket and stand the iron upright.
˃
Turn the temperature control dial (6) to the desired temperature setting.
˃
˃ The desired temperature has been reached when the pilot light has turned off. The
pilot light will turn on and off from time to time, indicating that the selected
temperature is being maintained.
Steam ironing
This function can be used only at higher ironing temperature.
●● for moderate steam
●●● or MAX for maximum steam
˃ Fill water into the iron as described on page 3.
Stand the iron upright.
˃
˃ Connect he iron to a suitable mains supply outlet
˃ Turn the temperature control dial(6) to the "●●", "●●●"or MAX setting
˃ The pilot light turns off when the required temperature is reached. The iron is ready
for use.
Turn the steam control knob(3) to the required position, steam starts coming out
˃
from the holes in the sole plate.
Notice: With conventional steam ironing ,water may leak from the sole plate if too
low a temperature has been select. If this happens, turn the temperature control
dial(6) to the advised position. Steam will recommence as soon as the appropriate
temperature has been reached.
Burst of steam
This function provides an extra amount of steam to remove stubborn wrinkles.
˃ Fill the iron with water as described on page 3.
Turn the temperature control to the position "MAX"
˃
The pilot light turns off when the required temperature is reached
˃
˃ The iron is ready for use
˃ Press the Burst of Steam button (5) once
˃ Steam will penetrate into the garment removing the wrinkles
Wait a few seconds before pressing the steam control knob again when there are
˃
stubborn wrinkles
Usually all wrinkles can be removed within three pressings
Dry ironing
Connect the iron to a suitable mains supply outlet.
˃
˃ Ensure that the steam control knob(3) is in position"0"
˃ Select the setting on the temperature control dial(6).
When the pilot light turns off, the required temperature is reached. The iron is ready
˃
for use.
UK 15