Functional Test - WIKA WU-20 Manual De Instrucciones

7. Starting, operation
Specifications
Ex-protection
Ignition protection type
Assembly and packing area
Packaging
Shock resistance
Vibration resistance
Wiring protection
Short-circuit proofness
■
Reverse polarity protection
■
Weight
When designing your plant, take into account that the stated values (e.g.burst pressure, over
pressure safety) apply depending on the material, thread and sealing element used.

Functional test

The output signal must be proportional to the pressure. If not, this might point to a damage of the diaphragm.
In that case refer to chapter 10 „Troubleshooting".
WARNING!
Open pressure connections only after the system is without pressure!
■
Observe the ambient and working conditions outlined in section 7 „Technical data.
■
Please make sure that the transducer is only used within the over load threshold limit at all
■
times!
CAUTION!
When touching the transducer, keep in mind that the surfaces of the instrument components
might get hot during operation.
16 WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio, WU-2X
Models WU-20, WU-25 and WU-26
FM Class I (for transducer with FM-marking)
Nonincendive for Use in Class I, Division 2, Groups A, B, C & D, and Class I, Zone 2,
Group IIC, Hazardous (Classified) Locations
Clean room class 5 according to ISO 14644
Double bagging according to SEMI E49.6
500 (1.5 ms) according to IEC 60068-2-27
0.35 mm (10 - 58 Hz) / 5 g (58.1 - 2000 Hz) according to IEC 60068-2-6
S+ towards U-
U+ towards U-
kg Approx. 0.1
GB