Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Changing Oil
•
Place generator on a level surface.
•
Run the generator for several minutes until the engine is warm. Turn off generator.
•
Remove screws, then remove outer casing side cover.
•
Remove the crankcase dipstick.
•
Place an oil pan underneath the engine. Tilt generator to collect used oil. Allow oil to drain completely.
•
Return generator to a level surface.
•
Carefully add 4-Cycle engine oil to empty reservoir until oil reaches the outer edge of the oil fill hole
(Crankcase Dipstick hole).
•
Use a clean rag to wipe up any spilled oil.
•
Replace crankcase dipstick.
•
Reinstall outer casing side cover and tighten screws.
Recommended Engine Oil: See Oil Recommendations on page 15.
Recommended Engine Oil Grade: API Service SE type or higher quality of engine oil.
Engine Oil Quantity: 0.35L (11.8 oz)
English
MAINTENANCE
MAINTENANCE
Do not tilt generator when adding oil. This could
result in overfilling which could damage the engine.
Make sure no foreign matter enters the crankcase.
16
Customer Hotline 1-800-445-1805
Publicidad
Tabla de contenido
