Ironing With Steam Blast; Ironing With The Spray Function; Temporarily Setting The Steam Iron Aside; Taking The Steam Iron Out Of Service - Lervia KH 1282 Instrucciones De Uso

IB_KH1282_E5554_UK_5
Drip-Stop Function
This iron is fitted with a Drip-Stop function. It prevents
the dripping of water from the ironing sole
the iron is switched off and when steam ironing.
When steam ironing, the iron must be set to at least
level ••. Consequently, first set the steam controller
s
to "Steam" when the temperature control knob
is set to at least level •• and the temperature has
been reached. Otherwise, water could leak from the
i
ironing sole .

Ironing with steam blast

The steam blast is especially suitable for smoothing
difficult to reach parts of a garment.
Note: Steam-blast is first possible from level
•••.
• Slightly raise the steam iron.
• For one steam blast, press the steam blast button
d
once.
Ironing with the spray
function
• To moisten the laundry, press the spray button
q
.
This function is suitable for very dry and very crum-
pled garments.
Temporarily setting the
steam iron aside
Fire hazard!
Never leave the steam iron unattended when it is
hot or switched on.
• Adjust the temperature controller
06.09.2007 15:32 Uhr
i
when
u
u
to "Min".
- 28 -
Seite 28
• Stand the steam iron on its back end
or
• Lay the steam iron in the support provided on the
ironing board.
Important: NEVER place the steam iron on
unsuitable surfaces. Risk of fire!
Taking the steam iron out
of service
• Remove the power plug from the wall socket.
• Allow the steam iron to cool down.
y
• Drain the water tank in that you open up the
o
water fill opening and either tip the contents
out to the side (see Fig.1) or empty it by tipping it
up to the front (see Fig.2).
Fig.1
Fig.2
• Clean the sole of the iron
"Cleaning and care").
e
• Coil the power cable
retainer at the back end of the iron
• Place the cooled down steam iron horizontally
onto a soft and clean surface.
t
.
i
(see chapter
around the power cable
t
.