Switching On The Product - nedis RDFM4000WT Guia De Inicio Rapido

•
After extended periods of storage, it may be
necessary to charge and discharge the cells or
batteries several times to obtain maximum
performance.
•
Battery usage by children should be supervised.
•
Remove the batteries if you do not use the
product for an extended period of time.
•
Unplug the product if you do not plan on using
the product for an extended period of time.
•
Do not use the product near water.
• Do not expose the product to direct sunlight,
naked flames or heat.
•
When the product is not used for an extended
period, store the product in a dry place away
from sunlight and protect it against excessive
dust and dirt.
•
Do not open the product. There are no user
serviceable parts inside.
•
Do not put hands and foreign objects inside the
product.
• Keep the product away from magnetic or
magnetized objects.
•
Extended exposure to high volumes can cause
hearing loss.
Installing the product on a flat
surface
4
1. Unfold the stands A
2. Place the product on a flat surface close to a
power outlet.
Installing the product under
cupboard (image B, C, D)
4
The cupboard floor thickness should be at least
16 mm.
4
Install the product close to a power outlet.
4
Use a screwdriver to fix the screws.
Do not plug the power cable A
-
outlet during the installation.
- Do not use any accessories that are not included.
Do not install the product under a cupboard with
-
a lighting strip installed underneath.
- Do not install the product above places were
steam and water can get in contact with the
product.
.
r
into the power
Inserting the batteries (image E)
1. Open the battery compartment A
2. Insert 2 AA batteries.
- Make sure to match the (+) and (-) polarity
markings.
3
3. Close A
.
Connecting the product to a power
source
• Plug the power cable A

Switching on the product

• Press the power button A
product.
6
• Press A
while the product is switched on to
switch to standby mode.
4
In standby mode the time and date are shown on
the LCD display A
4
The display is automatically dimmed between
23:00 – 05:00 h
Controlling the product
4 Rotate the volume wheel A
volume to the desired sound level.
4 Rotate the tune wheel A
press the set button A
4 Rotate and hold A
reverse values.
Setting the clock
1. Switch the product to standby mode.
9
2. Press A
.
3. Set the current minutes and confirm.
4. Set the current hours and confirm.
5. Set the clock to 24 hour or 12 hour setting and
confirm.
Setting the calendar
1. Switch the product to standby mode.
2. Press the mode button A
4 The month, day and year appear on A
9
3. Press A .
4. Set the current day and confirm.
5. Set the current month and confirm.
6. Set the current year and confirm.
6
3
.
r
into the power outlet.
6
to switch on the
q
.
7
to adjust the
o
to adjust values and
9
to confirm a setting.
o
to rapidly advance or
5
.
q
.