Orbegozo SF 0147 Manual De Instrucciones página 13

SF 0147 – SF 0148
ASSEMBLY
Fitting the pedestal
− Insert firmly the stand bar in the round base,
− Screw the stand bar to the base. Insert the screw and the washer under the round base and screw it
firmly.
− Extract the telescopic tube until the height desired. Adjust spinning the thread
− Install the fan's body over the stand bar and tighten the screws
Assemble the guard cover and protective ring
− Put the rear grille in the motor with the fasten nut. The handle should keep in the upper part.
− Put the protective ring which will fix both grille
Install fan blade
− Place the fan blades onto the motor spindle, making sure that the slot on the blade assembly lines
up with the key on the motor spindle. Then tighten the fixing nut of fan blade anticlockwise.
13