Cembre B68M-P18 Manual De Uso página 15

4.3) Choosing the "release mode"
The phase of discharging the oil into the pump's tank can be carried out in two diff erent ways,
depending on the mode set in the menu:
Release
mode
SMART
factory setting
MANUAL
To change the "release mode", proceed as follows:
- Select screen 4 from the "main menu" (Ref. to § 4.1).
- Hold the finger on the button (13) until a confirmation "beep" is heard, the choice made is shown
by positioning of the cursor under the pictogram.
4.4) Enabling/disabling the LED Worklights
LED
ON
LED
OFF
4.5) Return to original factory settings / fi rmware version
Select screen 10 from the "main menu" (Ref. to § 4.1), to return the pump to its factory settinghold
the finger on the button (13) until a confirmation "beep" is heard.
RESET
The RESET screen also shows the fi rmware version of the control board.
SW:S1J41405
15
Associated
pictogram
By releasing the start button the oil is returned in full to the pump
reservoir only following automatic shut-off of the motor. During
the return phase, pressing the buttons enables the head ram stroke
to be interrupted at any point so as to be able to restart from this
position in the next work phase, thus saving time and energy.
To return the oil to the pump reservoir it is necessary to press and
hold the release button.
During the return phase, by releasing the button it is possible for
head ram stroke to be interrupted at any point so as to be able
to restart from this position in the next work phase, thus saving
time and energy.
LED
OFF
LED
BEEP
ON
Function
(factory setting LED ON)
Select screen 8 from the "main menu" (Ref.
to § 4.1), to deactivate or reactivate ope-
ration of the LED Worklights hold the fin-
ger on the button (13) until a confirmation
"beep" is heard.